Dead Tree Removal in Georgia means more than dropping a trunk. It means reading the lean, checking the root plate, and rigging the wood down before it hits your roof, fence or power line. We run 24/7 crews across the state for homeowners, property managers and municipalities. If a dead pine is hanging over your driveway, call us now.
Dead Tree Removal in Georgia is the controlled felling, rigging and hauling of a tree that has died from drought, pine beetles, lightning, root rot or storm damage. A dead tree loses flexibility in the wood, so it snaps instead of bending. We inspect the trunk with a sounding mallet and a probe, check the root flare for decay, then decide whether to climb and rig it down in sections or take it from the ground with a controlled notch and back cut. Every cut is planned around what the tree can hit.
Georgia's climate drives a lot of this work. Summer heat and drought stress pines and oaks across the Piedmont, while the wetter coastal plain grows fungi that rot root systems from below. A tree that leafed out fine last spring can be standing dead by fall. If you are searching for dead tree removal near me and the tree is already dropping bark or leaning past 15 degrees, that is a same-day call, not a next-month project.
Every dead tree removal job includes the assessment, the cutting, the rigging, the cleanup and the haul-off. Stump grinding is included unless you ask us to leave the stump for a planter or a grinding access issue prevents it. Here is the line-by-line breakdown of what you are paying for.
A crew lead sounds the trunk, checks the root flare and identifies the failure mode before any cut. You get a firm price and a plan for the drop zone. This step is what keeps the job safe.
We climb and rig sections down when the drop zone is tight, or use a controlled notch and back cut when it is open. Rigging slings, blocks and ropes keep the wood on our side of the line.
All limbs and brush go through a wood chipper on site. You can keep the chips for mulch or we haul them. Nothing is left in a pile for you to deal with.
Trunk sections are cut to manageable lengths and loaded for hauling. If you want firewood, we can leave it cut to length or run it through a log splitter for an added fee.
We grind the stump below grade with a stump grinder so you can replant or lay sod. Grind depth is typically 6 to 8 inches, and the grindings are raked back into the hole.
We rake the work area, blow off the driveway and walk the property with you. If equipment left tracks in the turf, we note it and dress the area before we leave.
You call +18664591318 and describe the tree: how tall, how close to the house, whether it is leaning, and if any lines are involved. We ask the questions that determine whether this is an emergency or a scheduled job. If it is an emergency, we roll a crew immediately, day or night.
A crew lead walks the property, checks the root flare, sounds the trunk and looks at the canopy for deadwood. We identify the drop zone, the rigging anchor points and any obstacles like fences, sheds or septic lines. You get a firm price before any saw starts.
For tight drops we climb and rig sections down with ropes and rigging blocks. For open drops we use a controlled notch and back cut with wedges. Bucket trucks or cranes handle the tall stuff when access allows. Every cut is planned so nothing lands where it should not.
We feed the brush through a wood chipper and load the logs for hauling. The stump gets ground below grade with a stump grinder unless you want it left for a planter. We rake the work area and blow off the driveway before we leave. Most jobs are finished in two to six hours.
You walk the property with the crew lead. We point out the stump grind depth, the cleared drop zone and any turf damage from the equipment. If you want the chips left for mulch, we will pile them where you want them. Payment is due when you are satisfied with the cleanup.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Primary cutting saws for felling, bucking and limbing. We run sharp chains and fresh 2-cycle fuel mix on every job, and we carry spare bars and chains in case we hit metal or grit in the trunk.
Used when the tree is accessible from the road or a driveway. The bucket lets us work the canopy from above without climbing, which is faster and safer on tall dead pines with brittle tops.
The core of tight-drop work. Rigging slings, rigging blocks and ropes let us lower sections under control when the tree is over a roof, fence or driveway. This is how we avoid dropping wood where it does not belong.
Feeds limbs and brush into chips on site, which cuts hauling volume and keeps the job clean. You can keep the chips for mulch or we haul them off with the logs.
Grinds the stump below grade after the tree is down. We replace stump grinding teeth regularly so the cut stays clean and the grind depth is consistent, typically 6 to 8 inches.
For trees we cannot reach with the bucket truck. Climbing spikes get the climber into position, and a pole saw handles small dead limbs that are too high or too brittle to reach by hand.
A 70-foot dead loblolly pine was leaning 18 degrees toward a two-story house after a summer storm. The root plate was lifting on one side. The homeowner had been told by another company that it could not be removed without a crane.
We rigged the tree from a neighboring oak and lowered it in 12 sections over four hours. No crane was needed. The roof was untouched, the stump was ground 8 inches below grade, and the yard was raked clean the same day.
A dead white oak had dropped three limbs on a gravel driveway in Woodstock over two months. The trunk was hollow at the base and the canopy was full of deadwood. The family was parking on the street to avoid the drop zone.
We removed the deadwood first, then felled the trunk into an open area away from the driveway. The stump was ground and the logs were hauled. Total job time was three hours, and the driveway was clear by lunch.
A dead pecan had fallen partway and hung up in a live oak after a spring storm in Dublin. The trunk was suspended 15 feet off the ground and shifting in the wind. It was over a shed and a fence line.
We rigged the hung trunk, cut it free in two sections and lowered both to the ground without touching the shed. The live oak was inspected and needed only one dead limb removed. The job was done in two and a half hours.
Dead trees cause a predictable set of problems, and they get worse with every storm. Here are the calls we run most often and how we handle them.
Ask a pro →We rig the tree against the lean and lower it in sections away from the structure. Climbing spikes and rigging blocks let us control every piece. Most leaning removals are done in three to five hours with no damage to the house.
We climb the tree, remove the deadwood from the canopy and lower it with rigging ropes. If the whole tree is dead, we take it down in one visit. You get a cleared canopy and a roof that is not taking hits.
We section the trunk with a chainsaw, lift or roll the pieces clear, and haul the wood away. If the tree is still standing but threatening the drive, we rig it down in the opposite direction. Most driveway clearings are done in two to four hours.
We coordinate with the utility, assess the clearance and rig the tree away from the conductors. Our crews follow OSHA 1910.269 line-clearance practices. We do not touch energized lines, but we can safely remove the tree once the utility clears the work zone.
$400 - $1,800 depending on tree size, access and rigging needs
Dead tree removal cost in Georgia depends on the tree, the access and the drop zone. Typical 2026 pricing for a residential removal runs $400 to $1,800, with stump grinding adding $100 to $400. Tight rigging jobs near a house or line sit at the top of that range because they take longer and more gear. Open felling on rural acreage sits at the bottom. You get a firm price on site before we cut, and the number covers the crew, the equipment and the cleanup.
The price covers a licensed, insured crew, the rigging gear, the haul-off and the stump grind. Compare that to a roof repair or a fence replacement after a dead tree falls, and early removal is the cheaper call every time.
A 40-foot dead dogwood is a different job than a 90-foot dead pine. Height drives the rigging time and the equipment needed. Diameter affects how many sections we cut and how long the stump grind takes.
If the tree has room to fall, the job is faster and cheaper. If it is over a roof, a fence or a driveway, we rig it down in sections, which adds labor hours. Tight access for the chipper or bucket truck also raises the price.
Trees near service drops require coordination with the utility and extra care. We do not touch energized lines, but we plan the work around them. That planning adds time and sometimes requires a utility crew on site.
Stump grinding is priced by diameter and typically runs $100 to $400. Haul-off is included for the logs and chips. If you want the chips left for mulch, that can reduce the hauling cost slightly.
“We had a dead pine leaning toward the house after a July storm. The crew showed up the same night, rigged it down in sections and had the stump ground by morning. You could not tell a tree had been there except for the fresh chips. Fair price and no mess left behind.”
Marcus T.Homeowner, Sandy Springs
✓ Verified“I manage six rental properties and one had a dead oak over the driveway. They quoted on site, came back the next morning and had it down and hauled in four hours. The tenants never lost driveway access. I have used them three times since for other dead trees.”
Denise R.Property Manager, Woodstock
✓ Verified“A dead pecan was dropping limbs on my shed every time the wind blew. The crew climbed it, rigged the sections away from the shed and chipped everything on site. They even left me the wood chips for the garden. Straight answers and a clean job.”
Ray B.Homeowner, Dublin
✓ VerifiedMost residential dead tree removals in Georgia run $400 to $1,800 in 2026, with simple open drops on the low end and tight rigging jobs near structures on the high end. Stump grinding adds $100 to $400 depending on diameter. Emergency and after-hours calls carry a premium. You get a firm price on site before any cutting starts.
Look for bark sloughing off in sheets, no green under the outer bark when you scratch it, and brittle twigs that snap instead of bending. A dead pine usually turns gray and drops its needles in one season. If the trunk sounds hollow when you thump it, or you see conks at the base, call us for an assessment.
Call a licensed and insured tree service with ISA Certified Arborist credentials and rigging experience. We handle dead tree removal statewide, including tight drops near houses and lines. If the tree is leaning or already dropping limbs, call +18664591318 and we will triage it over the phone.
Yes, dead trees are more dangerous than live ones because the wood is brittle and can snap without warning. Root plates on dead pines often fail suddenly. That is why we rig sections down instead of dropping whole trunks near structures. Never cut a dead tree yourself if it is within reach of a house or power line.
We run dead tree removal service Georgia-wide, from the Atlanta metro to the coastal plain and the mountains. Our crews know the local tree species, the soil and the weather that kills them. If you are searching for dead tree removal near me and your town is on this list, we cover you. If it is not, call anyway. We work the rural routes between these cities too.
Emergency Tree RemovalWhen a dead tree has already cracked and is hanging, our emergency crews respond 24/7. We stabilize, rig and remove the hazard before it finishes falling on your house or car.Explore →
24/7 Tree RemovalDead trees do not wait for business hours. Our night crews run the same equipment and follow the same rigging standards as our day crews, so a 3 a.m. call gets a real removal, not a tarp.Explore →
Storm Damage Tree RemovalAfter a Georgia thunderstorm or ice event, dead trees are the first to fail. We clear storm-damaged trunks, broken tops and hung-up limbs from roofs, driveways and fences.Explore →
Fallen Tree RemovalA dead tree that has already fallen still needs controlled cutting and hauling. We section the trunk, lift it off structures when needed, and haul the wood away.Explore →
Tree Removal After HurricaneCoastal Georgia takes hurricane hits that snap dead pines like matchsticks. We handle post-storm removals from Savannah to St. Marys, including trees tangled in lines and fences.Explore →
Hazardous Tree RemovalLeaning, hollow or split trees get a hazard assessment before any cut. We identify the failure mode, plan the rigging, and remove the tree before it chooses its own direction.Explore →
Leaning Tree RemovalA dead tree that has started to lean is telling you the root plate is failing. We rig it against the lean and lower it in sections instead of dropping it with the lean.Explore →
Emergency Tree CuttingSometimes the fastest fix is to cut the tree off a structure and clean up after. We do emergency cutting to free roofs, vehicles and access roads, then finish the removal.Explore →A dead tree gets more dangerous every week it stands. We answer 24/7, quote on site, and remove the hazard before it removes something you own. Licensed, insured and rigging-ready statewide. Call now and we will triage your tree over the phone.
Call Now +18664591318 →Phone lines are open every hour of every day, including holidays and the middle of a storm. Tell us what the tree is touching and where you are, and we will give you a range on the spot and dispatch the nearest crew. Most metro Atlanta calls see a truck within 60 to 90 minutes.